The short version of GHRH analog fits in a sentence. The long version — which is the one that helps — is below.
This page was last updated on 2025-09-12 and is reviewed periodically as new material appears.
Characterization of this peptide relies on a small set of routine techniques. Reversed-phase high-performance liquid chromatography separates the target from truncated or oxidized by-products and yields a purity estimate when paired with ultraviolet detection near 214 nanometers. Mass spectrometry, either electrospray coupled to liquid chromatography or matrix-assisted laser desorption, confirms that the observed mass matches the value calculated for the expected sequence. Amino acid analysis, and enzymatic digestion followed by fragment mapping, are used when the sequence itself rather than the mass requires verification.
Stability depends heavily on physical state. A lyophilized powder kept dry, desiccated, and shielded from light typically holds its integrity for months to years at minus twenty degrees Celsius, and longer at minus eighty. Once dissolved, the peptide becomes far more vulnerable, since peptide bond hydrolysis, oxidation of susceptible residues, and aggregation all proceed faster in solution. Buffers near neutral pH are generally gentler than strongly acidic or alkaline conditions. Repeated freeze-thaw cycles and exposure to air-liquid interfaces during vigorous mixing cause losses that are easy to overlook.
Verification matters because research peptides vary widely in quality. A certificate of analysis is only as reliable as the method behind it, and a single chromatographic trace reveals little about counter-ions, residual solvents, or water content. Independent laboratories commonly pair mass confirmation with chromatographic purity and, where relevant, quantify water along with acetate or trifluoroacetate content. Reported purity figures are not standardized across suppliers, so a stated value such as ninety-eight percent is not directly comparable unless the analytical method, column, and detection wavelength accompany it.
The peptide backbone corresponds to GRF(1-29), the first 29 residues of native growth hormone-releasing hormone, which retains most of the receptor-activating activity of the full-length molecule. Four substitutions distinguish the analog from the natural sequence: D-alanine at position 2, glutamine at position 8, alanine at position 15, and leucine at position 27. These changes slow cleavage by dipeptidyl peptidase IV, the enzyme that degrades native hormone in plasma within minutes. The outcome is improved enzymatic stability combined with a still brief residence time when no additional modification is present.
Naming in this area is inconsistent, and readers should treat product labels with care. In much of the literature and in vendor catalogs, the unqualified term refers to the albumin-binding version, while the version lacking the DAC group appears as modified GRF(1-29), mod GRF(1-29), or the same name with a without-DAC qualifier. Because one abbreviation has been applied to both materials, the only reliable way to identify a sample is to check the stated sequence and the presence of the linker.
CJC-1295 is the name used for a synthetic peptide modeled on growth hormone-releasing hormone, the hypothalamic signal that prompts the pituitary to release growth hormone. The compound was described by a Canadian drug discovery company in the mid-2000s as a long-acting research tool. Two closely related molecules share the name in practice: one carries a drug affinity complex, or DAC, group, and one does not. The distinction matters because the two behave differently in circulation.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Assessed by visual inspection under ordinary light |
| Primary analytical method | Reversed-phase liquid chromatography | Purity estimated from peak area at 214 nm |
| Confirmatory method | Mass spectrometry | Observed mass compared with calculated value |
| Powder storage temperature | Minus 20 degrees Celsius | Minus 80 for extended archival periods |
| Solution stability | Hours to days at 2 to 8 degrees Celsius | Influenced by pH, buffer, and concentration |
Purity is most often assessed by reversed-phase high-performance liquid chromatography, reported as a percentage of total peak area. Identity is confirmed by mass spectrometry, which yields a molecular ion consistent with the expected sequence. Amino acid analysis and peptide mapping provide additional characterization. Reported purity values are method-dependent, so figures from different laboratories are not always directly comparable without details of column, gradient, and detection wavelength.
Peptide degradation proceeds mainly through hydrolysis, oxidation of methionine, and deamidation of asparagine or glutamine residues. The maleimide group on the albumin-binding variant can also react with thiols or hydrolyze in aqueous media. Because these pathways accelerate with temperature and pH extremes, handling conditions strongly influence measured stability. Stability data in the public literature are limited and often generated under differing conditions, so general statements about shelf life should be read as approximate.
Research material is normally supplied as a freeze-dried powder in sealed vials. In that state the peptide is comparatively robust, but prolonged exposure to warmth, moisture, or light accelerates degradation. Storage at minus twenty degrees Celsius or lower, with desiccant and protection from light, is the commonly described practice. Vials should be allowed to reach room temperature before opening to limit condensation on the powder. Moisture uptake during handling is a recognized source of variability in later measurements.
Identity and purity are established with reversed phase high performance liquid chromatography coupled to mass spectrometry. The chromatographic step separates the target peptide from truncated sequences and deletion products, while the mass measurement confirms the expected molecular weight to within a fraction of a dalton. Because the two common variants differ by the presence of the linker, mass alone can distinguish them in the unconjugated state. Amino acid analysis and peptide mapping are used when sequence level confirmation is required.
Lyophilized material is generally stable for extended periods when held at minus twenty degrees Celsius or below and protected from moisture and light. In solution the peptide is more labile; bond hydrolysis, aggregation and oxidation of susceptible residues all proceed faster at ambient temperature. Repeated freeze and thaw cycles should be avoided because they promote clumping and loss of soluble material. The conjugated variant adds a further consideration, since the maleimide group can hydrolyze in aqueous buffer and lose its ability to react with albumin.
Laboratory handling centers on minimizing exposure to water, heat and oxygen before use. Working solutions are typically prepared in sterile water or a mild buffer, and any residual particulate matter is removed by filtration. When the powder dissolves slowly, a small proportion of acetonitrile or dilute acetic acid is sometimes added as a co-solvent. Containers are kept sealed and desiccated between uses. Records of lot number, reconstitution date and storage conditions support later comparison of results across experiments.
He remained director of the NIH facility until the NIH no longer funded such facilities and retired from his teaching position in 2006. The MS Facility continued to operate after funding stopped through the efforts of Watson, the Biochemistry and Chemistry Departments.
On the 20th anniversary in November 2024, Valve made Half-Life 2 temporarily free on Steam and updated it to incorporate Episode One, Episode Two and Lost Coast, improve graphics and controls, restore lost content, fix bugs and add developer commentary. Half-Life 2 reached a new peak of 64,085 concurrent players on Steam, surpassing the previous record of 16,101 in August 2021. Valve also released a two-hour making-of documentary.
), as shown by the equations. The distribution coefficient is calculated as the ratio between the concentration of the metal cations in the organic and aqueous phase, whereas the separation factor is calculated as the ratio between the two distribution coefficients.
== Coupled reactions == Since energy is released when ATP is broken down, energy is required to rebuild or resynthesize it. The building blocks of ATP synthesis are the by-products of its breakdown; adenosine diphosphate (ADP) and inorganic phosphate (Pi). The energy for ATP resynthesis comes from three different series of chemical reactions that take place within the body. Two of the three depend upon the food eaten, whereas the other depends upon a chemical compound called phosphocreatine. The energy released from any of these three series of reactions is utilized in reactions that resynthesize ATP. The separate reactions are functionally linked in such a way that the energy released by one is used by the other. Three processes can synthesize ATP:
Sources: en.wikipedia.org
Yawn and swallow during ascent and descent Use the Valsalva maneuver during ascent and descent Avoid sleeping during takeoffs and landings Use an over the counter nasal spray Using filtered earplugs which slowly equalize the pressure against the eardrum during ascents and descents Outside of a pressurized cabin environment at very high altitudes, a pressure suit is the usual protective measure and is the definitive protection in decompression and exposure to vacuum, but they are expensive, heavy, bulky, restrict mobility, cause thermal regulatory problems, and reduce comfort. To prevent injury from unavoidable pressure changes, similar equalization techniques and relatively slow pressure changes are required, which in turn require patent Eustachian tubes and sinuses.
== Definition == Polycythemia is defined as serum hematocrit (Hct) or hemoglobin (HgB) exceeding normal ranges expected for age and gender, typically Hct >49% in healthy adult men and >48% in women, or HgB >16.5 g/dL in men or >16.0 g/dL in women. The definition is different for neonates and varies by age in children.
An arterial embolism is caused by one or more emboli getting stuck in an artery and blocking blood flow, causing ischemia, possibly resulting in infarction with tissue death (necrosis). Individuals with arterial thrombosis or embolism often develop collateral circulation to compensate for the loss of arterial flow. However, it takes time for sufficient collateral circulation to develop, making affected areas more vulnerable for sudden occlusion by embolisation than for e.g. gradual occlusion as in atherosclerosis.
Sources: en.wikipedia.org
Mass spectrometry establishes whether the observed molecular weight matches the calculated sequence mass. Chromatographic retention and fragment mapping add further confidence about sequence and composition. A single technique alone is rarely treated as sufficient evidence of identity.
Dry powder is markedly more stable than solution and is usually held frozen and desiccated. Room temperature exposure over days degrades it more slowly than most people assume, but long-term integrity favors freezer storage. Light protection is recommended regardless of temperature.
Methods, columns, gradients, and detection wavelengths are not standardized across laboratories. Some figures describe only the main peak area at one wavelength and ignore water, salts, or counter-ions. Without stated conditions, comparing reported percentages across sources is unreliable.
No. It is a laboratory-made analog of growth hormone-releasing hormone. The natural hormone is a 44-residue peptide, while the analog is built on a shorter 29-residue fragment.